Photovoltaic modules operating under outdoor conditions are susceptible to multi-source damage including micro-cracks and bypass diode faults, which progressively deteriorate power output and may lead to catastrophic failure. The conventional detection techniques such as electroluminescence imaging require darkroom conditions, limiting their applicability for in-situ inspection. To overcome these challenges, Lock-in Photoluminescence (LIPL) imaging technique was proposed for in-situ detection of typical defects in silicon-based photovoltaic modules. Firstly, an equivalent circuit model integrating dual-diode subcircuits for healthy and defective regions was established to simulate the electrical behavior and luminescence response of defective solar cells. The influence of key parameters, including series resistance, parallel resistance, and saturation current density on luminescence intensity was investigated. Subsequently, a dual-channel lock-in photoluminescence algorithm was developed for in-situ detection under sunlight. An in-situ experimental detection system was established to conduct defect detection on photovoltaic module samples containing multi-source faults. The results demonstrate that LIPL enables reliable in-situ defect detection under both sunlight and partial shading, clearly resolving carrier concentration non-uniformity and defect locations. Compared to traditional PL and EL methods, the LIPL algorithm achieves higher detection contrast and enhances the defect signal-to-noise ratio by 17.6% and 82.2%, respectively. This study provides a theoretical foundation and practical solution for non-contact in-situ inspection of photovoltaic modules.

Lock-in photoluminescence imaging for enhancing in-situ detection of multi-source damage in photovoltaic modules

Sfarra, Stefano;
2026-01-01

Abstract

Photovoltaic modules operating under outdoor conditions are susceptible to multi-source damage including micro-cracks and bypass diode faults, which progressively deteriorate power output and may lead to catastrophic failure. The conventional detection techniques such as electroluminescence imaging require darkroom conditions, limiting their applicability for in-situ inspection. To overcome these challenges, Lock-in Photoluminescence (LIPL) imaging technique was proposed for in-situ detection of typical defects in silicon-based photovoltaic modules. Firstly, an equivalent circuit model integrating dual-diode subcircuits for healthy and defective regions was established to simulate the electrical behavior and luminescence response of defective solar cells. The influence of key parameters, including series resistance, parallel resistance, and saturation current density on luminescence intensity was investigated. Subsequently, a dual-channel lock-in photoluminescence algorithm was developed for in-situ detection under sunlight. An in-situ experimental detection system was established to conduct defect detection on photovoltaic module samples containing multi-source faults. The results demonstrate that LIPL enables reliable in-situ defect detection under both sunlight and partial shading, clearly resolving carrier concentration non-uniformity and defect locations. Compared to traditional PL and EL methods, the LIPL algorithm achieves higher detection contrast and enhances the defect signal-to-noise ratio by 17.6% and 82.2%, respectively. This study provides a theoretical foundation and practical solution for non-contact in-situ inspection of photovoltaic modules.
File in questo prodotto:
Non ci sono file associati a questo prodotto.
Pubblicazioni consigliate

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11697/290343
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 0
  • ???jsp.display-item.citation.isi??? 0
social impact